Installing the brake and clutch reservoir can kit

The reservoir can conversion kit is show at the left.

Locate the holes

A printable template for drilling the holes is available here.  Check that the scale is maintained by your printer wth the dimensioned edge at the top.

Secure the clamps to the wheel housing with the stainless steel button head screws.

Check that the compression fittings at the top of the lines are tight.

Trim the original hoses to fit over the steel tubing from the cans.  Clamp the ends.

Note that there is a nut inside the can that secures the fitting on the bottom.  The internal nut must be held when the bottom fitting is tightened.